5 LED Blink Fast in Sequence

Facebooktwittergoogle_plusredditlinkedintumblrmailFacebooktwittergoogle_plusredditlinkedintumblrmail

 

 

New video can be viewed on The eTextile Lounge youTube channel.

Arduino Code can be uploaded to ATtiny45 using the Arduino as ISP Tutorial.

/*Five LED Blink Fast in Sequence*/
/*Arduino Uno v.1.0.3 as ISP for Atmel ATtiny45 internal 8MHz clock*/
/*14 Ocotber 2014*/
/*lynne bruning for The eTextile Lounge*/
/*http://etextilelounge.com*/

// led is attached to pin
int led1 = 0;
int led2 = 1;
int led3 = 2;
int led4 = 3;
int led5 = 4;

// the setup routine runs once when you press reset

void setup()

{
// initialize the digital pin as an output
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
pinMode(led3, OUTPUT);
pinMode(led4, OUTPUT);
pinMode(led5, OUTPUT);
}

// the loop routine runs over and over again forever

void loop()

{
digitalWrite(led1, HIGH); // turn the LED on (HIGH is the voltage level)
delay(100); // wait for a second
digitalWrite(led1, LOW); // turn the LED off (LOW is the voltage level)
delay(100); // wait for a second

digitalWrite(led2, HIGH);
delay(100);
digitalWrite(led2, LOW);
delay(100);

digitalWrite(led3, HIGH);
delay(100);
digitalWrite(led3, LOW);
delay(100);

digitalWrite(led4, HIGH);
delay(100);
digitalWrite(led4, LOW);
delay(100);

digitalWrite(led5, HIGH);
delay(100);
digitalWrite(led5, LOW);
delay(100);
}

 

When you upload the code you will receive the following information on the Arduino window:

Binary sketch size: 1,014 bytes (of a 4,096 byte maximum)

Error Message – Ignore
avrdude: please define PAGEL and BS2 signals in the configuration file for part ATtiny45
avrdude: please define PAGEL and BS2 signals in the configuration file for part ATtiny45

Facebooktwittergoogle_plusredditlinkedintumblrmailFacebooktwittergoogle_plusredditlinkedintumblrmail