Arduino Breadboard Blink 5 LEDs in Sequence

Facebooktwittergoogle_plusredditlinkedintumblrmailFacebooktwittergoogle_plusredditlinkedintumblrmail

 
How to set up a breadboard circuit for ATtiny45 to blink five LEDs in sequence.
 
ATtiny45  Arduino sequential blink program with 5 LED
 

BREADBOARD CONNECTIONS

ATtiny Pin 0 to LED positive (signal, white)
ATtiny VCC (+) to power positive (+, red)

ATtiny GND (-) to power negative (-, black)

LED negative to resistor (breadboard connection)
Resistor to negative power (-, black)

repeat for Pin 1, Pin 2, Pin 3, and Pin 4
 
ATtiny45-85 

CODE

Upload the following code to an ATtiny45 by following my tutorial on How to Use Ardunio ISP to Program ATtiny45
 

/*Five LED blink in Sequence Fast with ATtiny45*/
/*9 January 2014*/
/*lynne bruning*/
/*denver*/

int led1 = 0;
int led2 = 1;
int led3 = 2;
int led4 = 3;
int led5 = 4;

// the setup routine runs once when you press reset:
void setup()

// initialize the digital pin as an output.

{
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
pinMode(led3, OUTPUT);
pinMode(led4, OUTPUT);
pinMode(led5, OUTPUT);
}

// the loop routine runs over and over again forever:
void loop()

{
digitalWrite(led1, HIGH); // turn the LED on (HIGH is the voltage level)
delay(100); // wait for a second
digitalWrite(led1, LOW); // turn the LED off (LOW is the voltage level)
delay(100); // wait for a second

digitalWrite(led2, HIGH);
delay(100);
digitalWrite(led2, LOW);
delay(100);

digitalWrite(led3, HIGH);
delay(100);
digitalWrite(led3, LOW);
delay(100);

digitalWrite(led4, HIGH);
delay(100);
digitalWrite(led4, LOW);
delay(100);

digitalWrite(led5, HIGH);
delay(100);
digitalWrite(led5, LOW);
delay(100);
}
 

Facebooktwittergoogle_plusredditlinkedintumblrmailFacebooktwittergoogle_plusredditlinkedintumblrmail